Project Log‎ > ‎

Oval Door Cover

posted Mar 27, 2013, 7:11 PM by Jay Gross   [ updated Jan 1, 2016, 9:05 PM by Benjamin Gross ]
Not all parts are exciting or complicated. No scanning is actually required since the part was measured easily with calipers and an angle gage. The handle is formed by a putting a wire into the slot and not in the model.  Part can be produced by just CNC or manual machining with a rotary table. Displayed with permission from Kevin Sprayberry.
    

Part is around 3.5 inches tall.

   
   
         
      
 

Not too tricky, we did re-center the slots for the door handle.