Project Log‎ > ‎

Bell Yoke and Bracket

posted Mar 27, 2013, 7:10 PM by Jay Gross   [ updated Jan 1, 2016, 9:06 PM by Benjamin Gross ]
We did this project as 2 separate parts. The models were made directly from old rail road drawings. These parts were produced in rapid prototype direct to stainless steel at Shapeways.com. The parts are only a few inches long. Models and final product displayed with permission from Kevin Sprayberry.
 
 
This is the drawing.
 
 
 
          
Here are the SolidWorks Models. Note the inner web/fillet was unnecessarily removed for manufacturing considerations.
 
 
 
         
Here are the finished parts. 1/2 inch "T" slot in backround for scale.